All about bicycles, electric-assisted bikes, technology and safety in the press

The most common safety risks that we come across in our daily work around bicycle safety, technology and operating instructions are also published by us in articles in the leading German special-interest magazines TOUR (Europe's road bike magazine no. 1), BIKE (Europe's mountain bike magazine no. 1), MYBIKE and EMTB in order to make this information, which is important for the industry, available to a wider public.

For many years now, the Eurobike Show Daily, trade fair magazine of the annual Eurobike Show, has also given us the opportunity to publish our view of major developments in the cycle industry in full-page articles.

We also speak regularly in independent expert presentations about all areas of bicycle technology and the bicycle market. In addition, we are quoted by further special-interest magazines of the industry and the trade as well as increasingly by radio and television in their media reports, which shows us that we are spot on with our advice. The section "News" informs you about the latest news from our specialist areas. The reports and publications of this section are listed chronologically or according to areas of interest.

Die Rheinpfalz, June 26, 2008
Reading time 1:30 minutes

In the spotlight: extreme material carbon

(...) Carbon is completely different from aluminium or steel - the fibre material has become very popular. (...) But "lightweight and cheap" didn't work with aluminium and even less with the "sensitive material carbon". 

This is something, the sworn bike expert Dirk Zedler from Ludwigsburg can totally agree with. (...) As far as carbon is concerned, Zedler is of the opinion that: "Bad products of negligent manufacturers or wrong usage can damage the reputation of a basically good material." Furthermore, he considers carbon not to be the material of choice for all kinds of bikes: "It does not make a lot of sense for trekking bikes which are left standig outside unobserved the whole day."

Interview:

DR: Mr Zedler, do you have more work now than before the carbon-frenzy set in?

DZ: Yes. There are drastically more damaged frames. Not necessarily due to accidents, but because of things which would normally be small problems but become really big ones with carbon frames.

DR: For example?

DZ: You lean you bike against something, it falls over. There would be a dent in an aluminium frame, a carbon one cracks - maybe invisibly. The people come here to be on the safe side.

(...)

DR: Which parts are especially sensitive and endangered?

DZ: Basically the weight-bearing parts are always critical: handlebars, seatpost, stem and fork. Our experience as expert testers is that you can make sensational parts out of carbon. But you can just as well produce parts which look the same, but are technically really bad. You should therefore only buy such parts from the most reputable source.

DR: Are the manufacturers careful enough when producing such parts?

DZ: There are considerable differences. You can make the best things out of carbon - or the worst. What is so crazy about it: Most carbon stuff is made in the same region in China. And there, manufacturer A has fantastic things produced while manufacturer B has really bad stuff made in the same company.

(...)

DR: Are there no legal requirements or standards for these products?

DZ: There are, but they only are minimum standards which apply for the European Union. And there are not exactly demanding.

Go back